configure tacacs-accounting server client-ip

configure tacacs-accounting [primary | secondary] server [host_ipaddr | host_ipV6addr | hostname] {tcp_port} client-ip [client_ipaddress | client_ipv6address] {vr vr_name}

Description

Configures the server information for a TACACS+ accounting server.

Syntax Description


primary	Configures the primary TACACS+ server.
secondary	Configures the secondary TACACS+ server.
`host_ipaddr`	The IP address of the TACACS+ server being configured.
`host_ipV6addr`	The IPv6 address of the TACACS+ accounting server being configured.
`hostname`	The host name of the TACACS+ server being configured.
`tcp_port`	The TCP port to use to contact the TACACS+ server.
`client_ipaddr`	The IP address used by the switch to identify itself when communicating with the TACACS+ server.
`client_ipV6addr`	The client IPv6 address used by the switch to identify itself when communicating with the TACACS+ accounting server.
`vr_name`	Specifies the virtual router on which the client IP is located. Note: User-created VRs are supported only on the platforms listed for this feature in the Switch Engine v33.1.1 Licensing Guide document.

Default

N/A.

Usage Guidelines

Use this command to configure the server information for a TACACS+ accounting server.

To remove a server, use the following command:

unconfigure tacacs-accounting server [primary | secondary]

Use of the hostname parameter requires that DNS be enabled.

Example

The following command configures accounting server tacacs1 as the primary TACACS+ server for client switch 10.10.20.35 using a virtual router interface of VR-Default:

configure tacacs-accounting primary server tacacs1 client-ip 10.10.20.35 vr vr-Default

Example

The following command configures IPv6 server 1111::220 as the primary TACACS+ accounting server for client switch 1111::170 using virtual router interface of vr-mgmt:

# configure tacacs-accounting primary server 1111::220 client-ip 1111::170 vr vr-mgmt

History

This command was first available in ExtremeXOS 10.1.

IPv6 support was added in ExtremeXOS 32.6.

Platform Availability

This command is available on all Universal switches supported in this document.